Internet stability test: check jitter, packet loss and drops
A speed test tells you how fast your connection can go. A stability test tells you whether it holds steady for calls, games and streams. Here's how to run one in a few minutes and read the results.
Run a test that reports jitter and packet loss, not just speed, such as Cloudflare's speed test, then a bufferbloat test to see what happens when the line is busy. A stable connection keeps jitter under 30 ms and packet loss under 1%, the limits Microsoft and Cisco use for calls. If you see drops, test on Ethernet next to the router before blaming your provider.
Stability vs. speed: what you're actually testing
A fast connection can still be a bad one. Video calls freeze, games rubber-band and streams buffer when packets arrive late, out of step or not at all. Three numbers tell you whether your connection is stable:
- Latency (ping): how long a packet takes to make a round trip, in milliseconds.
- Jitter: how much that delay changes from one packet to the next. High jitter makes voices sound robotic.
- Packet loss: the share of packets that never arrive. Downloads quietly resend them; calls and games can't, so you hear gaps or see lag.
A fourth problem, bufferbloat, is latency that spikes only when someone is uploading or downloading. An idle speed test misses it completely.
What good numbers look like
These are the limits Microsoft sets for Teams calls over a home connection, Wi-Fi included. Cisco's long-standing voice guidelines are similar: jitter of 30 ms or less and packet loss of 1% or less.
| Measure | Good | Expect problems |
|---|---|---|
| Ping (round trip) | Under 100 ms | Over 100 ms: talk-over on calls, lag in games |
| Jitter | Under 30 ms | Over 30 ms: robotic audio, frozen video |
| Packet loss | Under 1% | Over 1%: gaps in calls, rubber-banding in games |
| Latency under load | A few ms above idle | Tens or hundreds of ms above idle: bufferbloat |
How to run an internet stability test (5 minutes)
- Plug in if you can. Connect a laptop to the router with an Ethernet cable. That takes Wi-Fi out of the picture, so a bad result points at your line or provider.
- Pause big downloads and streams on other devices for a clean baseline.
- Run Cloudflare's speed test (speed.cloudflare.com). Along with speed it reports latency, jitter, latency while downloading and uploading, and packet loss.
- Run a bufferbloat test such as Waveform's. It loads your line and grades how much your ping rises, from A+ (barely any) down to F.
- Repeat at a bad time. Test again in the evening, or whenever the drops happen. Problems that show up only at 8 p.m. usually mean congestion on the provider's side.
- Repeat on Wi-Fi from the room where you have trouble. If Wi-Fi is much worse than Ethernet, the fix is in your home, not with your provider.
For a quick speed and ping check first, use our speed test. For a comparison of tools, see the best internet speed tests.
Catch drops that come and go
A one-minute test can miss a connection that drops every half hour. A long ping test catches it. On Windows, open Command Prompt and type ping -t 1.1.1.1; press Ctrl+C when you're done and Windows shows how many packets were lost. On a Mac, open Terminal and type ping 1.1.1.1, then Ctrl+C for the summary.
Run it twice to find where the problem is:
- Ping your router (often 192.168.1.1 or 192.168.0.1; it's printed on the router or shown as the default gateway in your network settings). Losses here mean a Wi-Fi, cable or router problem in your home.
- Ping an outside address like 1.1.1.1. Losses here but not to the router point at your modem, line or provider.
On Windows, pathping 1.1.1.1 goes a step further: it reports loss at each stop along the route. Microsoft notes that loss at a middle stop doesn't always mean real loss: a busy router can drop test pings while still passing your traffic. Loss that continues all the way to the end is the kind that matters.
What to fix, based on your results
| What you see | Likely cause | Try this |
|---|---|---|
| Fine on Ethernet, bad on Wi-Fi | Weak signal, interference or a crowded channel | Move closer, use 5 GHz, or add mesh Wi-Fi |
| Ping jumps when someone downloads | Bufferbloat | Turn on smart queue management (SQM) or QoS in your router; see how to lower ping |
| Losses to the router itself | Bad cable, overheating or failing router | Swap the cable, restart the modem and router, check for firmware updates |
| Losses to 1.1.1.1 but not the router | Modem, line or provider problem | Check for outages, then call your provider with your test results |
| Bad only in the evening | Congestion on the provider's network | Log results for a few days; if it keeps happening, it's worth comparing providers |
If the connection cuts out completely rather than just stuttering, start with why your internet keeps disconnecting.
Take your results to your provider
Support agents usually start with a speed test, and a fast result ends the call. Bring stability numbers instead: screenshots of packet loss and jitter on Ethernet, the times they happened, and a long ping test showing loss to an outside address but not to your router. That shows the problem is past your equipment and is the evidence that gets a technician sent.
- Microsoft Learn: Understand Teams network requirements (client to Microsoft edge: latency under 100 ms round trip, packet loss under 1%, jitter under 30 ms), checked Nov 16, 2026
- Cisco Meraki: What is jitter? (Cisco voice guidelines: jitter 30 ms or less, loss 1% or less), checked Nov 16, 2026
- Cloudflare blog: How does Cloudflare's speed test really work?, checked Nov 16, 2026
- Microsoft Learn: pathping command, checked Nov 16, 2026
Targets are from Microsoft's Teams network requirements and Cisco's voice guidelines; tool details are from Cloudflare and Microsoft documentation (checked Nov 16, 2026). We haven't benchmarked these tools ourselves.
Prices and offers change often; confirm before you order. How we research
Jean founded ShopHighSpeed after trying to find one straight answer about business internet in his own town. He has been a Comcast and Verizon Fios customer, and ranks providers on what they actually deliver, not on what they advertise.